How to install and fix the Xi'an barrier system?
Determine the location first
Where it is easy to notice, the brake lever faces outward (intersection), the ground of the barrier needs to be on the same level as the pavement, and the surface of the pavement needs to be used as the foundation of the barrier.
Install the chassis
Remove the accessories from the box.
Place the box at a certain position, open the box door, use a marker or screwdriver to mark the hole on the bottom of the box, and remove the box.
Use an impact drill to drill expansion screws at a hole size of 70-80mm, insert expansion screws, adjust the horizontal and vertical degrees of the box, and tighten the nuts.
Install the brake lever
Open the door of the box and turn the motor handle to clamp the brake lever in the box to a horizontal position.
Put the end with the screw hole of the brake lever horizontally into the brake lever clamp groove in the box, put on the outer brake lever clamp, flat washer, and tighten the nut.
Adjust the gate lever bracket so that the gate lever is in a horizontal position. And the gate lever bracket is just in contact with the gate lever.
The installation method of the barrier rod holder is the same as that of the box.
Connect the power of the channel gate, and press the "▲" and "▼" keys of the controller to make the lever move 90 degrees up and down 4 to 5 times. status.
Disconnect the power, open the box, loosen the box cover screws, and remove the box cover.
Use a hex wrench to adjust each tension spring screw. (See Figure 3) Make the brake rod achieve better results when the falling rod is running.
If there is a jitter phenomenon in the lift lever, the tension of the balance spring is too large, repeat the above operation (relax the spring screws to make the brake lever achieve better results when the lever is running.)
If the motor is running and the brake lever does not move when the lever is lifted, it indicates that the tension of the balance tension spring is insufficient. Adjust the state of the tension spring or increase the tension spring until the brake lever operates normally.
The stand-alone spring configuration is as follows:
The length of the brake lever is 6 meters with two tension springs, the length of the gear lever is 4-5 meters with two tension springs, and the length of the brake lever is 4 meters or less.
During the adjustment, the number of rotations of each nut is the same to avoid unbalanced forces.
When the gate is delivered, the balance state of the brake lever is adjusted to reach the range of balance. If the brake lever is not vertical or horizontal when it is installed on site, the steps are as follows:
Open the box door
Use a Phillips screwdriver to loosen the crosshead screws of the stopper baffle, turn the stopper baffle slightly to adjust the brake lever to a horizontal position, and tighten the screws after adjustment;
When the lever is not in place, the limit stopper will be fine-tuned in the opposite direction, and vice versa if it exceeds the horizontal position;
When the lever cannot reach the verticality after the lever is lifted, finely adjust the limit stop clockwise to the desired position;
Lock the door.
Generally simple barrier faults can be solved according to the following 3 methods. If your barriers have the following 3 faults, it is recommended to ask a professional to repair it.
The above article, I will tell you about this place, thank you for reading, if you also have this need, you are welcome to log in to our company's website at any time, we will publish articles on this site Share with everyone!